山东润境环境科技有限公司专注于山东实验室装修设计,仪器设备,培训一体化工程!
咨询热线:
0531-67805633
客服热线 :18654548277 13658639555

您现在所在的位置 :首页 - 新闻资讯 > 公司新闻 >

公司新闻

news

全国统一咨询热线

0531-67805633 

山东润境环境科技有限公司

地址:济南市历下区理想嘉园1号楼1310室

服务热线:
18654548277
13658639555

咨询热线:0531-67805633

公司新闻

无尘车间温湿度调节及试验方法!

来源:http://www.sdrunjing.com/ 日期:2020-04-20 发布人:润静小编
  无尘车间温度试验包括功能温度试验和一般温度试验。无尘室净化工程中各级空气清洁度的空气净化处理应采用初级、中等、空气过滤器。10万级空气净化处理,可代替hepa过滤器使用hepa过滤器。目前,无尘车间的等级是航空航天航空仓库,基本上属于一级,属于面积相对较小的特殊领域。
  The temperature test of dust-free workshop includes function temperature test and general temperature test. Primary, medium and high efficiency air filters shall be used for the air purification treatment of all levels of air cleanliness in the clean room purification project. HEPA filter can be used instead of HEPA filter. At present, the highest level of the dust-free workshop is the aerospace warehouse, which basically belongs to the first level and belongs to the special field with relatively small area.
  此外,生化实验室和高精度纳米材料生产车间也需要更高的水平。物联网芯片的发展将是未来需求的一个主要方向。净化工程是指对产品(如硅片等)与大气的接触进行清洁和温湿度的控制,使产品能在良好的环境空间内生产、制造。该环境空间的设计与施工过程可称之为净化工程。功能温度测试主要用于无尘车间,当温度精度需要严格控制或施工人员需要静态或动态测试时,一般温度测试主要用于空气温度测试。
  In addition, biochemical laboratory and high-precision nano material production workshop also need higher level. The development of Internet of things chip will be a main direction of future demand. Purification engineering refers to the cleaning of products (such as silicon chips) in contact with the atmosphere and the control of temperature and humidity, so that products can be produced and manufactured in a good environment. The design and construction process of the environmental space can be called purification engineering. The functional temperature test is mainly used in the dust-free workshop. When the temperature accuracy needs to be strictly controlled or the construction personnel needs static or dynamic test, the general temperature test is mainly used for air temperature test.
山东实验室装修设计
  功能温度测试的无尘车间、洁净区域应划分为相等的区域网格,每个网格面积不得超过100平方米,或者应当通过谈判确定建设党,每个网格测量点应大于1,和每个房间都有至少2点测量。工作面高度、顶距、墙体、地面应不小于300mm,并考虑热源的影响。测量时间至少为1H,至少一次为6min,读数稳定后记录。测点高度应为工作面高度,测量时间不少于1H,测量时间不少于一次,连续6分钟。读数稳定后记录。
  The dust-free workshop and clean area for functional temperature test shall be divided into equal area grids, each grid area shall not exceed 100 square meters, or the construction party shall be determined through negotiation, each grid measurement point shall be greater than 1, and each room shall have at least 2 points of measurement. The height of working face, top distance, wall and ground shall not be less than 300 mm, and the influence of heat source shall be considered. The measurement time shall be 1H at least and 6min at least once. Record after the reading is stable. The height of the measuring point shall be the height of the working face, the measuring time shall not be less than 1h, and the measuring time shall not be less than once, lasting for 6 minutes. Record after the reading is stable.
  无尘车间湿度测试:湿度测试可通湿、干球湿度计、电容式湿度计、数字式湿度计、毛发式湿度计。
  Humidity test of dust-free workshop: humidity test can be conducted with psychrometer, dry bulb hygrometer, capacitance hygrometer, digital hygrometer and hair hygrometer.

友情链接: 苏州净化器租赁 自行车车棚